Whirlpool · Washer · Error code

E2371 – Generic washer fault E2371

Whirlpool washer is reporting error E2371, indicating a general fault related to operation or sensors.

Severity: Low · Typical fix time: 60–120 minutes · Affects: Whirlpool Washer Series 8

AI helper

Smart summary for E2371

This quick AI-style overview sums up how serious this error is, how hard it usually is to fix yourself and roughly how long it takes.

Risk level Low
DIY difficulty Easy – most people can try these checks.
Typical time to resolve 60–120 minutes

What E2371 means

Error E2371 on many Whirlpool washer models is used as a generic fault code. It usually points to a problem detected by the control board, such as a sensor reading outside the expected range or a cycle that could not complete.

Common causes

  • Temporary software glitch or power fluctuation
  • Blocked filter, hose or internal passage
  • Sensor or wiring connection not making good contact

Quick checks you can do yourself

  1. Turn the appliance off at the mains and leave it powered down for a few minutes.
  2. Check and clean accessible filters, drains and hoses for blockages.
  3. Inspect the door or lid area for obstructions preventing a good seal.
  4. Restart a short cycle and monitor the appliance to see if the error returns.

Always unplug the appliance and switch off power at the mains before removing panels or working near wiring or water connections.

When to call a professional

If error E2371 reappears after simple checks and a power reset, there could be an internal electronics or sensor fault. At that point it is safer to have a qualified engineer test the appliance rather than replacing control boards or wiring blindly.

Recommended next steps

If the appliance continues to work normally after a reset and cleaning, keep an eye on it for a few days. If the same error appears frequently or is accompanied by unusual noises or smells, stop using the appliance and arrange a professional inspection.