Beko · Washer · Error code
E1337 – Generic washer fault E1337
Beko washer is reporting error E1337, indicating a general fault related to operation or sensors.
Smart summary for E1337
This quick AI-style overview sums up how serious this error is, how hard it usually is to fix yourself and roughly how long it takes.
What E1337 means
Error E1337 on many Beko washer models is used as a generic fault code. It usually points to a problem detected by the control board, such as a sensor reading outside the expected range or a cycle that could not complete.
Common causes
- Temporary software glitch or power fluctuation
- Blocked filter, hose or internal passage
- Sensor or wiring connection not making good contact
Quick checks you can do yourself
- Turn the appliance off at the mains and leave it powered down for a few minutes.
- Check and clean accessible filters, drains and hoses for blockages.
- Inspect the door or lid area for obstructions preventing a good seal.
- Restart a short cycle and monitor the appliance to see if the error returns.
Always unplug the appliance and switch off power at the mains before removing panels or working near wiring or water connections.
When to call a professional
If error E1337 reappears after simple checks and a power reset, there could be an internal electronics or sensor fault. At that point it is safer to have a qualified engineer test the appliance rather than replacing control boards or wiring blindly.
Recommended next steps
If the appliance continues to work normally after a reset and cleaning, keep an eye on it for a few days. If the same error appears frequently or is accompanied by unusual noises or smells, stop using the appliance and arrange a professional inspection.
Typical repair cost
£0–£130. In many cases, E1337 on a Beko washing machine can be solved with simple cleaning or checks. If a part like a pump, valve or sensor is faulty, a typical supplied-and-fitted cost is often £70–£130.
How to prevent this error in future
- Clean the pump filter and door seal regularly to prevent lint and debris from building up.
- Avoid overloading the drum so the machine can drain and spin correctly.
- Use the correct detergent dose to reduce suds and residue inside the machine.
- Run a maintenance wash at high temperature every month with a cleaner or detergent.
Recommended parts & cleaners
The link below searches for compatible parts, hoses and cleaners that may help resolve E1337 issues on your Beko washer. Always check compatibility with your exact model before ordering.
View related parts on Amazon Open Amazon search →FAQs for E1337
What does E1337 mean on a Beko washer?
Error E1337 on many Beko washer models is used as a generic fault code. It usually points to a problem detected by the control board, such as a sensor reading outside the expected range or a cycle that could not complete.
Can I keep using the washer with error E1337?
Usually you can do basic checks safely, but if you notice leaks, burning smells, unusual noises, or tripped electrics, stop and investigate before continuing.
How do I reset a Beko washer after this error?
A safe first reset is to power the appliance off at the socket (or isolator) for 60 seconds, then turn it back on. If the error returns immediately, focus on the causes listed above rather than repeated resets.
What is the most common fix for E1337?
Most commonly: Temporary software glitch or power fluctuation. Start with the first DIY checks and work down the list.
About this guide
This guide was created by the CodeSolveAI Appliance Help Team. We use manufacturer information, typical engineer reports and safe DIY practice to keep these pages up to date and practical.
Last reviewed: March 2026.
Was this page helpful?
Your feedback helps us improve these guides and keep them as practical as possible.